Swing Gate Operator | GTO PRO 3000 XL Gate Opener

GTO PRO 3000XL Swing Gate Opener/Operator

GTO Pro 3000 gate opener

Low Voltage Swing Gate Operator designed for tubular steel, vinyl, wood, or ornamental gates for residential, farm and light commercial use. The PRO3000XL is for single swing gates. Add the slave unit PRO3200XL for a double swing gate (below).

12 volt system, no electrician needed for installation
Gate will work during electrical power outage
Quick and easy installation, with user friendly instructions
Solar Panel Charger available for remote locations
Will operate a gate up to 16' long and weighing up to 650 lbs. each leaf.
Can operate 90 to 190 gate cycles during peak hours of operation, depending on gate size and weight (see cycle chart link below)
Control box can be mounted in protected area away from receiver (may require longer cables)
Receiver unit with antenna and 10' cable can be placed in best location for reception of signal
Can be operated by remote transmitter, digital keypad, push button or combination
Full systems capable "add on ready" heavy-duty control board includes adjustable obstruction sensing, gate sequencing and auto close settings (0-120 seconds).
High cycle capability with true soft start and stop operation
Full access ready package includes battery, radio receiver, entry transmitter, AC transformer, and all necessary mounting hardware for a standard installation.
Can operate as 'push to open' or 'pull to open' (specify when ordering - extra hardware required for push to open)
UL rated for Class I, II, III & IV. System certified to be in compliance with UL 325, 4th edition.
Two-year limited warranty applies to replacing parts from GTO, Inc.

:: Technical Specifications ::

Drive

Powered by resilient 12 volt motor, 64:1 planetary gear drive system.
Temperature rating of motor: -30ºF (-34ºC) to +160ºF (+71ºC)
Opening time is 18-20 seconds.
Range of arm stroke is up to 16" (41 cm), with arm fully retracted is 40.25" (102 cm), mounting point to mounting point.

Power

The PRO-SW3000 system is powered by a 12 volt DC/7.0 amp hour, sealed, rechargeable battery.
Optional second battery fits in control box, used for solar applications or high traffic applications, if needed
Battery charge maintained by a 120V AC/60 Htz input, transformer rectified to 14 V DC through the GTO Control Board. NOTE: Transformer should never be connected directly to any battery.
Optional GTO Solar Panel Charger: float voltage 14.5 V DC output from a 19-3/8" (49.21 cm) x 15-1/4" (38.74 cm) silicon alloy panel. Generates minimum of 10 watts at 600 mA. A gated diode on the control board prevents battery discharge.

Controls

The GTO control board can be programmed for pull-to-open or push-to-open.
Adjustable auto close, obstruction sensitivity and dual gate sequencing.
Slow Start/Stop for added cycles and system life.
Auto-memorization of digital transmitter code.
Charging regulated circuit on control board. "Sleep draw" is 40 mA; "active draw" is 2 to 7 amps.
GTO remote-mounted RF receiver tuned at 318 MHz.

Includes:

Operator arm
AC transformer
12 volt battery
Control box/control board
Receiver with 10 ft. cable
Entry transmitter
6 ft. power cable
Mounting hardware
Installation/safety manual
Caution signs.
Warning Beeper
Adjustable obstacle-reversing safety feature

$725.00 (plus $15.00 S&H)

or call toll-free to order at (877) 275-1270

PRO-SW3200XL Gate Opener

PRO-SW3200XL Gate Opener

GTO Slave Operator for PRO3000XL only

Add this unit to the PRO3000XL above and your system will operate a double swing gate up to 32' wide (16' each leaf). Burying the power cable directly across the driveway is fine. It can be snaked through conduit also. Cable is 1/4 inch diameter with a 1 inch plug on one end only.

Includes:

Operator arm
40' power cable - wires into the control box of the PRO3000XL
Mounting hardware
NOTE: This operator will not work as a stand-alone unit. It is a slave unit without a control box and is meant to hook up to the PRO3000XL control box for use with a double gate.
Includes battery, 1 button transmitter, and radio receiver
12 volt systems, no electrician needed for installation
Gate will work during electrical power outage
Adjustable obstruction sensing, auto closing, and gate sequencing

$413.00 (plus $10.00 S&H)

order by phone (1.877.275.1270) or online through our secure encrypted checkout system.

Shipping and Handling added automatically before checkout, please visit the Shipping page for more details. Southeast Gate Operators is not responsible for any typographical errors that may occur on this site, all prices are subject to change without prior notice.

SEGO sells electric, swing and slide gate openers nationwide and in Baton Rouge within driving distance of the following Louisiana areas: New Orleans, Lafayette, Chalmette, Kenner, Metairie, Slidell, Opelousas, Zachary, LaPlace, Bogalusa, Baker, Denham Springs, Donaldsonville and Mandeville. Please contact a local technician if you are seeking gate installation or to have hardware installed. SEGO offers nationwide shipping for Gate Operators and Gate Openers to the following areas: Mobile, Phoenix, Little Rock, Los Angeles, Denver, Boulder, Hartford, Dover, Miami, Atlanta, Boise, Chicago, and Indianapolis. Other cities that we can ship a sliding or swinging gate to include Topeka, Biloxi, Birmingham, Augusta, Annapolis, Boston, Lansing, Detroit, St. Paul, Biloxi, Santa Fe, Albany, Raleigh, Bismarck, Salem and Providence. Other cities within shipping range include Houston, Dallas, Amarillo, San Antonio, Salt Lake City, Richmond, Charleston, Madison and Cheyenne. Our swing and slide driveway gate openers for wrought iron or chain link fences would arrive fastest in states closest to Louisiana including Texas, Arkansas, Kentucky, Mississippi, Alabama, Georgia, Tennessee and Florida.