Low Voltage Swing Gate Operator designed for tubular steel, vinyl, wood, or ornamental gates for residential, farm and light commercial use. The PRO-SW2000XL is for single swing gates. The PRO-SW2002XL is for a double swing gate.

• 12 volt system, no electrician needed for installation

• Gate will work during electrical power outage

• Quick and easy installation, with user friendly instructions

• Solar Panel Charger available for remote locations

• Will operate a gate up to 12' long and weighing up to 400 lbs. each leaf.

• Can operate 105 to 185 gate cycles during peak hours of operation, depending on gate size and weight (see cycle chart link below)

• Control box can be mounted in protected area away from receiver (may require longer cables)

• Control box measures 18-1/2" high x 14-1/4" wide x 7-1/2" deep

• Receiver unit with antenna and 10' cable can be placed in best location for reception of signal

• Can be operated by remote transmitter, digital keypad, push button or combination

• Full systems capable "add on ready" heavy-duty control board includes adjustable obstruction sensing, gate sequencing and auto close settings (0-120 seconds).

• High cycle capability with true soft start and stop operation

• Full access ready package includes battery, radio receiver, entry transmitter, AC transformer, and all necessary mounting hardware for a standard installation.

• Can operate as 'push to open' or 'pull to open' (specify when ordering - extra hardware required for push to open)

• UL rated for Class I, II, III & IV. System certified to be in compliance with UL 325, 5th edition.

• Two-year limited warranty applies to replacing parts from GTO, Inc.

Technical Specifications:

Drive

• Powered by a reliable 12 Volt (120 Watt) DC motor, 16:1 planetary gear drive system.

• Temperature rating of motor: -5ºF (-21ºC) to +160ºF (+71ºC)

• Opening time is from 15 seconds.

• Range of arm stroke is up to 11" (0.3 m). Operator length with arm fully retracted is 33.25" (0.85 m), mounting point to mounting point.

Power

• The PRO-SW2000XL system is powered by one 12 volt DC/7.0 amp hour, sealed, rechargeable battery (included).

• Optional second battery fits in control box, used for solar applications or high traffic applications, if needed

• Battery charge maintained by a 120V AC/60 Htz input and 18V AC at 40 VA output, transformer rectified to 14 V DC through the GTO Control Board. NOTE: Transformer should never be connected directly to any battery.

• Optional GTO Solar Panel Charger: float voltage 14.5 V DC output from a 19-3/8" (49.21 cm) x 15-1/4" (38.74 cm) silicon alloy panel. Generates minimum of 10 watts at 600 mA. A gated diode on the control board prevents battery discharge.

Controls

• The GTO control board can be programmed for pull-to-open or push-to-open.

• Adjustable auto close, obstruction sensitivity and dual gate sequencing.

• Slow Start/Stop for added cycles and system life.

• Auto-memorization of digital transmitter code.

• Charging regulated circuit on control board. "Sleep draw" is 15 mA; "active draw" is 2 to 5 amps.

• GTO remote-mounted RF receiver tuned at 318 MHz.

Includes:

• Operator arm

• AC transformer

• 12 volt battery

• Control box/control board

• Receiver with 10 ft. cable

• Entry transmitter

• 6 ft. power cable

• Mounting hardware

• Installation/safety manual

• Caution signs.

• Warning Beeper

• Adjustable obstacle-reversing safety feature

$399.00  (plus $15.00 S&H)

or call toll-free to order at (877) 275-1270

GTO PRO SW2002XL Double Swing Gate Operator

 

The GTO PRO-SW2002XL system will operate a double swing gate up to 24' wide (12' each leaf). Burying the power cable directly across the driveway is fine. It can be snaked through conduit also. Cable is 1/4 inch diameter with a 1 inch plug on one end only. Can operate 53 to 93 gate cycles during peak hours of operation, depending on gate size and weight.

Includes:

• Master Operator arm with 6 ft. power cable

• Slave Operator arm with 32 ft. power cable

• AC transformer

• 12 volt battery

• Control box/control board

• Receiver with 10 ft. cable

• Entry transmitter

• Mounting hardware

• Installation/safety manual

• Caution signs.

• Warning Beeper

• Adjustable obstacle-reversing safety feature

$629.00  (plus $30.00 S&H)